DIY Slipper Socks
Need a last minute gift idea? Or just want to make a little something for yourself? I made my own slipper socks with scrap fabric and a thrifted sweatshirt, making this a very inexpensive DIY project.
Check out the tutorial below:
1. Gather your materials: decorative fabric for the top of the slipper, a thicker fabric (to make these extra cozy! I used a thrifted sweatshirt), pins, scissors, a sewing machine (or needle and thread).
2. Make your own pattern by tracing your foot, or use the pattern pieces I used. Download them here.
3. Fold your decorative fabric in half, wrong sides together. I used a stretch knit, so I didn’t worry about the grain. Place the first pattern piece (the one that looks like a 90’s telephone- see the slight resemblance?) down along the fold. Pin and cut.
4. If you add a half inch of seam allowance around all the pattern pieces, you will roughly end up with a size XL Women’s slipper sock. If you don’t include seam allowance, roughly a size L. For those with smaller feet, just trim the pattern pieces accordingly to fit your foot size.
5. Place the first pattern piece on your thicker fabric along the fold. (I used the sleeve of my sweatshirt.) Pin and cut.
6. Place your second pattern piece (the one that slightly resembles a foot) down on your thicker fabric. Pin and cut through two layers of fabric at the same time. The reason for this is because you will notice the second pattern piece is asymmetrical. This is to accommodate the big toe. Cutting through both layers at the same time helped it so I didn’t end up with two left feet.
7. Repeat steps 3-6 for the cutting out the other slipper sock. When cutting out your second pattern piece this time around though, place the pattern piece right side down on your fabric (so you end up with both feet). You will end up with four pieces per slipper sock, these will make the liner and the shell.
8. Fold your top pieces in half, right sides together. Pin the heel areas closed and sew.
9. This will leave you with asymmetrical loops of fabric.
10. Place your liner fabrics right side together on top of each other.
11. Pin around the entire edge of your pattern pieces.
12. When you get to the heel area, you will have excess fabric. Pinch and pin the heel area down to the second pattern piece.
13. At this point your work will start to resemble a slipper sock!
14. Sew around the entire circumference of your slipper sock.
15. Repeat pinning process with the shell fabric pieces.
16. Place your liner piece inside your shell piece, right sides together.
17. Sew them together, along the ankle area. Leave a small gap near the back seam.
18. Turn your slipper sock right side out via the hole you left.
19. Push your liner into your shell, and sew the hole closed.
20. Repeat with the other slipper sock.
Tada! You have some custom-made slipper socks! If you are worried about slipping while wearing them, just take puffy paint and add some dots to the sole of your slipper socks. (My mom used to do this on my socks when I was little.)